Description: LUXMAN L-505Z Integrated Amplifier Blaster White AC100V use ships from Japan Description Electric circuit/function: Luxman's unique new amplified feedback engine LIFES 1.0, which replaces ODNF, is installed in the power amplifier circuit. ・High power rated output of 150W x 2 (4Ω) with 3-stage Darlington parallel push-pull configuration ・Electronically controlled attenuator LECUA that realizes 88 steps of high-definition volume control ・High inertia power supply combining EI type 540VA high regulation power transformer and large capacity capacitors (10,000μF x 4) ・Low resistance and large speaker relay with parallel configuration that supports high speaker drivability ・MM/MC compatible phono equalizer amplifier circuit that parallelizes the first stage and realizes even higher grade analog record playback ・Electronic bass/treble tone control and LR balance adjustment function controlled by LECUA ・Pre-power separation (separate) function that enables coexistence with bi-amplification configurations with additional power amplifiers and AV systems ・High-quality selector switch IC that improves left and right separation and crosstalk performance ・Beeline construction that configures transmitted audio signals using the optimal shortest route ・Round pattern wiring board for smooth current transmission ・Spiral wrap for each core ・Internal wiring design with unique OFC wire that achieves natural signal transmission with non-plating treatment of shield and core wire ・Exterior ・Needle-type analog meter with white LED lighting that smoothly follows changes in music signals ・7-segment LED mechanism for highly visible volume level display placed in the center of the large meter ・Ancillary equipment ・Independently constructed loopless chassis structure that shuts out increases in ground impedance due to chassis current ・18mm pitch RCA input/output terminal compatible with high-quality cables equipped with large plugs ・Speaker terminals (2 systems A and B) with an in-line (same characteristics for LR) layout that makes it easy to attach extra-thick cables and also supports Y-lugs and banana terminals. ・In addition to the Φ6.3mm standard terminal, a new headphone output with independent Φ4.4mm terminals for left and right ground wiring greatly improves LR separation. ・AC inlet whose mounting direction has been changed so that the entire terminal can support the weight of the cable. ・New control input/output terminal (Φ3.5mm monaural jack) that links remote control signals between compatible devices and expands support for remote control using other wireless devices in the future. ・Equipped with a new trigger input/output terminal that enables power linkage between compatible devices (Φ3.5mm monaural jack/daisy chain is also possible) ・High-quality aluminum remote control RA-17A that can also operate the CD player (compatible with major Luxman CD (SACD) players released after 1996) ・New power cable JPA-10000i with a non-twist structure that has evolved into a slim type that has a thicker conductor and is easier to handle than before. others ●Rated output: 100W+100W (8Ω), 150W+150W (4Ω) ●Input, separate input/output: 4 lines, 1 phono (MM/MC switching), 1 balanced line, 1 separate input/1 output ●Speaker Output: A, B2 system (AB simultaneous output possible) ●Volume adjustment: LECUA ●Amplification circuit, output configuration: LIFES 1.0, bipolar parallel push-pull ●Input sensitivity/input impedance: PHONO: (MM) 2.5mV/47kΩ, ( MC) 0.3mV/100Ω, LINE: 180mV/47kΩ, BAL LINE: 180mV/55kΩ ●Total harmonic distortion: 0.009% or less (1kHz/8Ω), 0.09% or less (20Hz to 20kHz/8Ω) ●S/N ratio , Frequency characteristics: LINE: 104dB or more, 20Hz to 100kHz (+0, -3.0dB) ●Attached equipment/Front panel section: Power switch, input selector, volume, headphone jack (Φ6.3/Φ4.4mm), speaker selector (OFF/A/B/A+B), Tone control (BASS/TREBLE), LR balance, LR meter, Volume level LED, Separate, Cartridge (MM/MC), Line straight, Remote control receiver/Can only be operated with the remote control: Loudness, mute, meter display - Rear panel: input/output terminal, ground terminal, balanced phase switch, trigger terminal, control terminal, AC inlet Power consumption: 270W (Electrical Appliance and Material Safety Act), 85W (when no input is applied), 0.5W (at standby) ●Maximum external dimensions: Mass 440 (W) x 178 (H) x 454 (including 20 front knobs and 27 rear terminals) (D) mm, 22.5 kg (main body) ●Accessories: Remote control (RA-17A ), power cable (JPA-10000i: with polarity mark) * Φ4.4mm headphone output is ground separated connection using an unbalanced amplifier. With compatible headphones, you can enjoy listening with high separation performance with independent wiring for left and right (-) signals. * Line cables are not included with this product. Please purchase separately. Search for other Luxman AV equipment AV equipment Luxman LUXMAN>Audio Luxman LUXMAN>Amplifier Luxman LUXMAN>Integrated amplifier Luxman LUXMAN Payment We accept PayPal only. Shipping I'll ship the item via FedEx or DHL asap without a shipping fee.I attach the tracking number.I will ship the item 5 business days after your payment clears.Shipping is only available to the address registered in Paypal.Please note that any address not registered in Paypal is not acceptable to ship. Terms of Sale Import duties, taxes, and charges are not included in the item price or shipping charges. These charges are the buyer's responsibility.Please check with your country's customs office to determine what these additional costs will be before bidding/buying.These charges are normally collected by the delivering freight (shipping) company or when you pick the item up - do not confuse them for additional shipping charges. Your Terms of Sale will be inserted here. International Buyers - Please Note: Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding or buying. Provided by HARU
Price: 3057.94 USD
Location: Tokyo
End Time: 2024-12-28T03:48:45.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: Luxman
Type: Integrated Amplifier
Audio Inputs: NA
Number of Channels: NA
Number of Inputs: NA
Model: L-505Z
MPN: Does not apply
Number of Outputs: NA