Description: Pascal Marani MPA-600TOutstanding PerformanceHigh power output: 2x900 W @ 4 Ohm Highly efficient Switch-Mode Power Supply Class H output circuitry Full protection circuitry including Over-Current, Over/Under-Voltage, Output DC and Over-Temperature Two XLR Link outputs for use in driving additional power amplifiers. Excellent sonic performance with 24bit high end converters coupled with 48kHz sample rateTop-grade DSP Engine28 band parametric equalization per channel, each band can be switched to Bell, Low/High Shelving variable Q 3 All Pass Filter, Bypass 1st order and 2nd order Crossover filters with slopes from 6dB/Octave up to 48dB/ Octave including Butterworth, Bessel, Linkwitz-Riley Precision dynamic range controller composed of a RMS Compressor with selectable ratio and variable knee Adjustable Delay time up to 900 ms per channel On each Channel is possible to use a two band RMS Compressor. Parametric Dynamic Filter Peak LimiterDirect PC/Network ConnectionFront panel USB connector for direct PC communications Ethernet interfaces (RS485 version also available) for system setup, monitoring and control via manageable remote PC software ControlFront panel interactive LCD display for local access and configuration Front panel 5-LED level meter indicators per channel Simultaneous control up to 32 units via PC software Up to 20 storable user presets Power & Amplifier sectionNumber of Channels2Output ModesStereo, Parallel-mono and Bridge-monoMax Output Power2 x 600W @ 8Ω 2 x 1000W @ 4Ω Output CircuitryClasse HTHD @ Rated power 4Ω (1kHz)<0.01%Dynamic Range105 dB (A-weighted, AES-17 filter)Frequency Response20Hz - 20kHz ±0.5 dBDamping Factor>200 (8Ω / 1kHz input signal)Power SuppliesSwitch mode power supplyOperating Range115V / 230V - 50/60 Hz (factory selection)Consumption / Current draw and Thermal dissipation @ 230 V74.8W / 0.76A / 255 BTU/h (Idle) 963W / 6.5A / 3286 BTU/h (I/8 max. power@4Ω) 1260W / 7.8A / 4300BTU/h (I/4 max. power@4Ω)ProtectionsOver-Current, Over/Under Voltage, Output DC and Over-TemperatureAnalog Input2 x XLR electronically balanced, +12dBAnalog Output2 x XLR electronically balanced (Link)Input Sensitivity0.775V, 1.2V, 1.6VFrequency Response (DSP)20-20KHz; -0.5dBu at 20Hz and 20kHzDSP & ProcessingDSP EngineMARANI M704 DSP Resolution24bit (data) x 24 bit (coeff.),54bit accumulation registers, 96 bit precision on intermediate processing data Parametric Equalization28 filters per channel selected as Bell or Shelving Filter TypeBell, Low/High Shelving variable QFilter GainFrom -12dBu up to +12dBu by 0.5dBu resolution stepsCenter FrequencySelectable with a 1/24th of octave resolution step from 20Hz up to 20kHzBell Filter Q/BWQ from 0.5 up to 10 by 0.1 resolution stepsLow/High ShelvingFilter QQ from 0.5 up to 3 by 0.1 resolution steps Crossover Section HPF/LPFButterworth 6/12/18/24/36/48dB per octave Linkwitz-Riley 12/24/36/48dB per octave Bessel 12/24dB per octave Filter resolution 1/24th of octave3 All Pass FiltersFrequency selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz Type: Bypass, 1st Order, 2nd Order; Q: from 0.5 to 9.9 step 0.1Dynamic FilterFrequency selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz Attenuation: from -6dB to 0dB; Q: from 0.1 to 10.0 step 0.1RMS CompressorThreshold from -30dBfs up to 0dBfs Attack time from 5ms up to 500ms; Release time from 40ms up to 1 sec Ratio from 2:1 to 100:1; Knee from 0%(Hard Knee) to 100% (Soft Knee) Make-Up: +/-18dBuPeak LimiterThreshold from -30dBfs up to 0dBfs Release time from 40ms up to 1 sec; Attack time from 1ms up to 100ms.Delay900 ms 21us increment/decrement steps per channelGeneralDevice Presets20 User PresetsFront Panel2x24 character LCD display with blue LED backlight 5-LED meter per channel (-6dB,-3dB, 0dB, limit, clip) Red LED (Protect) per channel NAV/PM1/LEVEL-A, NAV/PM2/LEVEL-B Rotary encoder push button switches Power on/off push button switch USB type B connectorRear Panel2 x XLR female connector (Input) 2 x XLR male connector (Link Output) 2 x Neutrik® Speakon NL4 (Speaker Output) 2 x Binding Post output (In parallel with Speakon® connectors). 2 x EtherCon® RJ45 connector (M-LAN RS485) or Ethernet 10/100 TCP-IP (T version only) 1 x 3-position slide switch Output Mode (Stereo, Parallel, Bridge) 1 x 3-position slide switch Input Sensitivity (0.775V, 1.2V, 1.6V) AC Power CordDimensions19"x 3.5"x 20.3" (483x89x515mm) 2RUWeight, Net / Shipping33.07 lbs (15 Kg) / 41.89 lbs (19 Kg)Call 801-771-1820 for any questionsOr go to SpeakersAndAmps.com CALL 801-771-1820 with any questions!!!We have distributed PRO AUDIO SPEAKERS and Amplifiers for 20 years. Go to SpeakersAndAmps.com to see!We have all the other major PRO Audio Speaker Brands and Models.We have many many more than you see here. We sell to Dealers as well.
Price: 799 USD
Location: Clearfield, Utah
End Time: 2024-03-04T23:30:50.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Type: Power Amplifier
Brand: Marani
Model: MPA2-600T
MPN: MPA2-600T
