Description: INSURE YOU SELECT THE PROPER FUEL TYPE AND BTU RATING FOR YOUR APPLICATION!! When in doubt ask us we will get back with you with in 1 business day This auction is for Straight Tube configurations you will need to select the system length, BTU requirement, Fuel Type. Each system is made and tested to insure that it is operational before shipping this can cause lead times to extend out 15 days during the peak heating season. We strive to shorten this lead time as much as possible, but want to insure that you are aware before you purchase! For a basic heat loss calculations for a residential garage contact us with the following information: Zip Code Dimensions of the heated space: L x W x HNumber and dimensions of Doors and WindowsHow do you want to use the heated space? Heat only when necessary or maintain a temperature?How will is the space heated? Excellent, Average, or Poor (Best fit is ok)"Excellent" Insulation Assumes the following with Dry walled interior: Walls: Insulated with to a R-19 rating Roof: Insulated with to a R-30 rating Garage Door: Insulated with to a R-15 rating Windows: Double pane with to a R-5 rating "Average" Insulation Assumes the following with Dry walled interior: Walls: Insulated with to a R-11 rating Roof: Insulated with to a R-11 rating Garage Door: Insulated with to a R-6 rating Windows: Double pane with to a R-2 rating "Poor" Insulation Assumes the following with an Un-finished interior: Walls: Wood Walls NO Insulation Roof: Wood roof with Asphalt shingles and NO Insulation Garage Door: Un-Insulated Steel garage door Windows: Single Pane with to a R-1 rating What is included: Burner - with 3 ft long 120 volt power cordStainless Steel Gas Connector - US OnlyAluminum ReflectorsReflector Hanger and SupportsHeat Treated Radiant tubesJoint sealer and ScrewsTurbulator (Pre installed in the last combustion tube)4" Vent CapLine Voltage Thermostat What you will need on your end: Consult your certified local HVAC installer before purchasing about the installation in many cases they require you to purchase though them to install.Insure that the installation is performed by a certified local HVAC installerThere are a additional venting material needed to connect the end of the system to the Vent Cap.Provide gas lines up to the heater, installation is performed by a certified local HVAC installerProvide a line voltage power source that would be controlled by the thermostat near the heater, installation is performed by a certified local HVAC installerHanging Chain and mounting materials Basics about the Serengeti-IR Residential Radiant Infrared Gas Fired Garage Heater Serengeti-IR 3.5™ (Powder Coated) Residential Radiant Infrared Tube Heaters the original dry tube gas fired system. Power vented system with BTU inputs available from 40K to 60K manufactured in the US. Energy Savings of 30-50% over Conventional Heating Systems. Pre Engineered Packages. Gas Fired, Unitary power vented systems. For use in Residential garages, Barns, Large Warehouses, Animal Confinement, Oil & Lube Shops, Auto Dealerships, Patio's, Brooders, Pole Barns, Bump Shops, Service Garages, Car & Truck Wash Bays, Shipping & Receiving Docks, Commercial Applications, Steel Warehousing, Greenhouses, Swimming Pools, Industrial Applications, Warehouses, and more! Features: 10 Year Warranty on Radiant Tubes For Internally Created Corrosion3 Year Warranty on all burner components3 Try Direct Spark Ignition - 100% Safety LockoutResidential Application CertifiedBurner Flame Inspection WindowCSA Certified (Formally A.G.A & CGA)Easy InstallationElectronic Flame MonitoringEmitter Tubing S.E.C. Designed for Optimum Efficiency and OutputEnergy Savings of 30-50% over Conventional Heating SystemsNatural Gas or Propane GasPowder Coated Burner HousingPre Purge CycleRadiant Tubing Constructed Entirely of Corrosion Resistant Aluminized SteelSpecifications: Manufacturer-Combustion Research Available BTU Ratings - 40K Btu's, 45K Btu's, 50K Btu's, 55K Btu's, 60K Btu's (Not all are listed if you don't see it and need it let us know) Fuel Type Availability - Natural Gas (NG), Propane Gas (LP) Voltage Requirement - 110VBurner Tube Diameter - 3.5 Inch Air Inlet Diameter - 4.0 Inch Exhaust Diameter - 4.0 Inch Exterior Finish - Powder Coated Why Choose Infrared Radiant Heat for Your Application? Whether you have a small garage or shop space or a large manufacturing plant or warehouse, infrared heaters are not only more efficient, they also provide a much more comfortable atmosphere than conventional forced air heating systems. What is an infrared heater? An infra-red heater is simply a hot surface heating appliance which, like our own sun, emits radiant (infrared) wave energy to surfaces below. When this infra-red energy strikes a surface or an object, the energy converts to heat which in turn heats the surrounding air. The sun does not heat the air, it heats the earth and the objects on it, and then those earth heat the air. That same infrared heating principle is a practical and effective way to heat building spaces. In an aircraft hangar, for example, multiple infrared heaters can be suspended from the ceiling with the emitters directed toward the floor below. The heaters are spaced appropriately to create heat uniformity and optimum comfort. The biggest heat source when you implement a properly designed radiant infra-red system, is no longer the heater itself, rather it is the floor which stores all the heat as well as objects within the building itself. What are the benefits of using infrared? Infrared energy heats from the floor up. Even though the infrared heaters are mounted up high (near the ceiling in most cases), the energy they emit does not convert to heat until it strikes the floor and objects at ground level. Heat is then stored and re-radiated to the surroundings. The result is warm floors, warm feet, and better use of energy. By contrast, forced air heating depends on the principle of warm air stratification. Using the aircraft hangar example, warm air must stratify from high up at the ceiling level all the way down to floor level. The result is cold floors, cold feet and high ceiling temperatures which results in wasted heat energy at the upper levels of the hangar. In addition to greater creature comfort, infrared heating systems can save as much as 50% or more in energy consumption compared to most forced air systems. Is infrared practical in my application? An infrared radiant tube heater can be sized to meet the heating needs of just about any building sizes and application. 400 square feet to 1,000,000 square feet or more it does not matter as long as the heat loss is covered. Residential garages, Commercial spaces, residential garages, Industrial buildings, Aircraft hangers, and more! While infrared heaters can save consumers as much as 50% in energy usage, the one benefit that gets overlooked most often is creature comfort. We have designed thousands of heating systems for every application. We commonly get clients that have existing unit heaters the owners complain of high gas bills. This is where we step in and help them design a system that will optimize the heating comfort in their space and save them money on their monthly billing. In many cases the system pays for itself in one heating season with the savings on their gas bills. In one application where the owner had 122,400 square feet and large cold masses to heat when using forced air unit heaters they were paying $106,000 per year in heating costs not to mention over 624,000 tons of CO2 emitted by the heating system each year. The biggest issue with this application was the sheer volume of cold masses being brought into the building. The system that was designed for them ultimately saved them over $36,000 per year and reduced their carbon foot print by over 213,000 Tons of CO2. This translated into a reduction of heating costs by 34% and a 35% reduction in carbon foot print. In other buildings and applications without large volumes of cold mass rotation we have seen savings up to 50%! With radiant infra-red heat you can expect to save 30-50% on your application with a properly designed system. What to expect with a properly designed system: · Your heating bills reduced for your application by 30%-50% over a forced air heating system · Reduction in your carbon foot print · Even heat distribution · Better overall comfort Normal 0 false false false EN-US X-NONE X-NONE On Dec-31-17 at 16:08:05 PST, seller added the following information:
Price: 1352 USD
Location: Rochester, Michigan
End Time: 2025-01-28T20:30:00.000Z
Shipping Cost: 200 USD
Product Images
Item Specifics
Restocking Fee: 20%
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Power Source: Electric, Gas, Natural Gas
Current Rating: Less Than 5 A
Material: Aluminum, Steel
MPN: Does Not Apply
Brand: Combustion Research Corporation
Type: Infrared
Control Style: thermostat, Analog/Mechanical
Unit Type: Unit
Heating System: Radiant
Manufacturer Warranty: 3 Years
Voltage: 120 V
Model: Serengeti-IR
Features: Ceiling Mounted, Gas Fired, Non-Condensing, Vented System, Polished Aluminum Reflectors, Heat Treated Radiant Tubes, Vent Cap Included, Line Voltage Thermostat Included
Country/Region of Manufacture: United States
Mounting Location: Ceiling
Smart Home Protocol: Infrared
Location: Garage \ Shop \ Barn
Available Variations
Color: Natural Gas (NG)
Price: 1502 USD
Available Quantity: 6
Quantity Sold: 1
Color: Natural Gas (NG)
Price: 1502 USD
Available Quantity: 3
Quantity Sold: 1
Color: Natural Gas (NG)
Price: 1634 USD
Available Quantity: 7
Quantity Sold: 2
Color: Propane Gas (LP)
Price: 1352 USD
Available Quantity: 6
Quantity Sold: 1
Color: Propane Gas (LP)
Price: 1502 USD
Available Quantity: 6
Quantity Sold: 1
Color: Propane Gas (LP)
Price: 1502 USD
Available Quantity: 8
Quantity Sold: 3
Color: Propane Gas (LP)
Price: 1634 USD
Available Quantity: 7
Quantity Sold: 2
Color: Natural Gas (NG)
Price: 1634 USD
Available Quantity: 7
Quantity Sold: 3
Color: Propane Gas (LP)
Price: 1634 USD
Available Quantity: 7
Quantity Sold: 4
